DTH Drill Bit DHD3.5-100

DTH Drill Bit DHD3.5-100

 

DHD shank DTH drill bit with convex face, 13 semi-ballistic carbide buttons for blasting bore holes, water well drilling.

ROSCHEN offers an extensive range of DTH hammer bits with shank type: DHD3.5, DHD340A, DHD3.5R, DHD360, DHD380; and DTH bits hole diameter: 3'', 4'', 5'', 6'', 8''(85mm-350mm).

Rock drilling tools:

Bit shank type of DHD series DTH Bits are designed to fit DTH hammers, which is the most popular design for blasting bore holes, water well drilling. In conjunction with DTH hammers, DTH hammer bits with DHD shank type are designed with a splined drive for rotating the bit in the ground. Rock drill bits in DHD shank are available in different sizes and different styles so they can drill a wide range of hole sizes.

 It is usually used as gauge buttons and front buttons of DTH Bits, suitable for medium abrasive and hard formations.

 

Down The Hole Hammer Introduction

 

1.    superior alloy steel:

Hardness and wear resistance combined alloy steel, supplied by national top level special steel manufacturer superior

2.    Longer Service Life:

All parts of the DTH hammer and bits are heat treated,longer life,less failure.

3.    High Efficiency:

More efficient energy transfer, faster drilling speed,15%-30% faster penetration than conventional DTH hammer.

4.    Saving Oil:

Lower air consumption and lower oil consumption.

5. Working pressure from 6 Bar to 35 Bar(0.6~ 3.5Mpa)

 

Down The Hole Hammer Features:

 

1. Button bit is well known for its high wear resistance on medium-hard to hard abrasive rock formations (between 2.0 Mpa to 2.6 Mpa compressive strength). Featuring spherical tungsten carbide inserts that is known to have strong configuration against carbide fracture.

2. Recommended for eliminating hole deviation.

3. Widely used drifting and tunneling.

4. Bit face design is ideal for medium-hard to hard abrasive rock.

 

Dth Hammer Drilling Tools Specifications: